Out With the Old: I Replaced My Garage Door Seal

The new black rubber bottom seal installed on my garage door, close up

Out with the old, and in with the new.

I replaced my garage door bottom seal, and the old one was done. Flat, wore out, and holding a layer of dirt like it was proud of it.

It wasn’t sealing anything anymore. It was just going along for the ride.

Here’s the old one, laying in the driveway after I pulled it out:

The old garage door seal, flat and wore out, laying on the driveway

My door is 18 feet wide, so that’s a long stretch of seal. The new one is a Holikme, 22 feet of EPDM rubber. I bought it long on purpose, so I’d have plenty to work with and trim at the end instead of coming up short. EPDM holds up better in the sun too, and this door faces east, so it takes the morning sun every day.

Holikme Garage Door Bottom Seal, 22 ft, EPDM

A 22 foot EPDM rubber bottom seal with 5/16 inch T-ends, made for double-track retainers like mine.

This is the exact seal I put on my 18 foot door. I bought it long, trimmed it to fit, and it seals like it's supposed to.

See it on Amazon

If you want the same one, there it is. Just check your door first: this one fits a double-track retainer with 5/16 inch T-ends, like mine. These seals ain’t one size fits all, and the wrong ends won’t slide in.

As jobs go, this one was fairly easy. I used a pair of pliers to pull the old one off, and that only took about a minute. Putting the new seal on took about 30 minutes. That part is easier with a second person there to hold the seal up while you put the new one on, so if you’ve got somebody around, grab them before you start.

Old one out, new one in. Here’s the new seal from underneath, running the whole width of the door:

The new garage door seal from underneath, running the full width of the door

The door seals up like it’s supposed to now. There’s one little thing left: at the end of the close, the opener clicks like it’s still trying to finish the job, and the door sits up about a half inch. Sounds like the travel needs a small adjustment, so that’s next on the list. Ain’t that always how it goes. You finish one job and it hands you the next one.

If yours is wore out like mine was, here’s how the job went, step by step:

  1. Check your retainer before you order. Mine is a double-track retainer with 5/16 inch T-ends, and the seal has to match it. These seals ain’t one size fits all.
  2. Buy a little long. My door is 18 feet, and I bought a 22 foot seal so I’d have plenty to work with and trim at the end instead of coming up short.
  3. Pull the old seal out. I grabbed it with a pair of pliers, and it came off in about a minute.
  4. Slide the new seal into the track. That took about 30 minutes, and it goes easier with a second person there to hold the seal up while you work it in.
  5. Trim the extra off the end, then close the door and check that it seals up all the way across.

Last check, from inside with the door shut: not a bit of light coming in under it. That’s how you know it sealed.

The closed garage door from inside, the new seal tight against the floor with no light coming in underneath

That’s fine. This is how a place gets kept up: one small job at a time, done right, and crossed off the list.

See y’all later,
John